Feb 25, 2021
In this episode, Bryan and Craig Migliaccio (AC Service Tech) talk about some best practices you can use while swaging and flaring copper.
There are a few different ways you can flare copper. Craig likes using a round deburring tool before flaring the copper. After the burr has been cleanly removed, Craig likes using an eccentric flaring tool for the actual flaring. Bryan's favorite flaring tool is the NAVAC battery-powered flaring tool for quick, accurate flares. Both Craig and Bryan agree that it's better not to deburr if you're likely to drop the burr or copper shavings into the tubing.
You can also use a tiny bit of Refrigeration Technologies Nylog on the flare face to make sure that the contact is sufficient and secure.
Along with flaring, we also have tube expansion or swaging. There are several tools you can use, including drill, hammer, and block swages. Craig likes to avoid swaging tools that leave large gaps; adding heat to make the swaging process smoother may result in oxidation. He prefers using a drill swage on downward-facing tubes; the drill swage can provide friction and heat while keeping the copper tube clean. Overall, Craig doesn't have a favorite swaging tool; he acknowledges that each swaging tool has an appropriate application. It's NOT a good idea to use a tube expander near the compressor.
Craig and Bryan also discuss:
Check out Craig's website at acservicetech.com.
Learn more about Refrigeration Technologies HERE.
If you have an iPhone, subscribe to the podcast HERE, and if you have an Android phone, subscribe HERE.